Remote Control Commands
R&S
®
SMBV100A
546Operating Manual 1407.6062.32 ─ 08
[:SOURce<hw>]:BB:ARB:WSEGment:CREate <Filename>
This command creates a multi segment waveform using the current settings of the speci-
fied configuration file. The multi segment waveform is saved into the file defined in the
configuration file. The file extension is *.wv.
Setting parameters:
<Filename> string
Example:
MMEM:CDIR '/var/smbv/user/waveform'
sets the default directory to /var/smbv/user/waveform.
BB:ARB:WSEG:CONF:SEL 'new'
creates the configuration file new.inf_mswv in the default direc-
tory.
BB:ARB:WSEG:CONF:SEGM:APP 'arb1.wv'
'includes waveform arb1.wv as segment 1 in the configuration
file. The waveform must be available in the default directory.
BB:ARB:WSEG:CONF:OFIL 'multi_wv1'
defines the file name multi_wv1.wv for the multi segment wave-
form.
BB:ARB:WSEG:CRE 'new'
creates multi segment waveform multi_wv1.wv using the set-
tings of the configuration file new.inf_mswv.
Usage:
Setting only
[:SOURce<hw>]:BB:ARB:WSEGment:NAME?
This command queries the name of the waveform of the currently output segment of the
multi segment waveform.
Return values:
<Name> string
Example:
BB:ARB:WSEG:NAME?
queries the currently output segment.
Usage: Query only
[:SOURce<hw>]:BB:ARB:WSEGment:NEXT <Next>
This command selects the segment to be output.
Parameters:
<Next> integer
Range: 0 to 1023
Increment: 1
*RST: 0
SOURce Subsystem
To Next Page
Loading...
