Preparing for Use
R&S
®
SMBV100A
25Operating Manual 1407.6062.32 ─ 08
●
Connection of memory stick for file transmission
●
Firmware update
Note: Another USB interface type A (host USB) and a USB interface type B (device USB
for data transmission) are available on the rear panel.
See also chapter 2.4.1, "Connecting USB Devices", on page 36.
2.2 Rear Panel Tour
This section gives an overview of connectors on the rear panel of the instrument. Each
connector is briefly described and a reference is given to the chapters containing detailed
information. For technical data of the connectors refer to the data sheet.
Fig. 2-2: Rear panel view
2.2.1
Description of the Connectors
I OUT / Q OUT
Direct output or Differential (non-inverting) output for analog I/Q signal.
See also chapter 5.6.3, "Output of the Baseband Signal - I/Q Out", on page 264.
I OUT BAR / Q OUT BAR
Differential (inverting) output for analog I/Q signal.
Rear Panel Tour
To Next Page
Loading...
