Preparing for Use
R&S
®
SMBV100A
26Operating Manual 1407.6062.32 ─ 08
See also chapter 5.6.3, "Output of the Baseband Signal - I/Q Out", on page 264.
MARKER 1, 2
Outputs 1 and 2 for triggering and control of external devices with user-definable marker
signals.
For more information see chapter 5.2.3.12, "Global Trigger/Clock/External Input Set-
tings", on page 121.
USB IN
USB (universal serial bus) interface of type B (device USB).
This interface can be used for remote control of the instrument.
USB CONNECTORS TYPE A
USB (universal serial bus) interfaces of type A (host USB).
●
Connection of peripherals such as mouse, keyboard, etc.
●
Connection of memory stick for file transmission
●
Firmware update
Further USB interface type A are available on the front panel.
See also chapter 2.4.1, "Connecting USB Devices", on page 36.
DIGITAL IQ IN/OUT
Connector for the input/output of a digital I/Q signal from/to an R&S instrument, like a
signal generator, analyzer or the R&S EX-IQ-BOX. The interface requires option R&S
SMBV-K18, Digital Baseband Connectivity.
LAN CONNECTOR
Ethernet interface
●
For integrating signal generators in a network
●
Remote control of signal generator
●
Remote access to the signal generator
●
Firmware update
See also:
● chapter 2.6, "Setting Up a Network (LAN) Connection", on page 38
● chapter 6.1.3, "LAN Interface", on page 394
HARD DISC
With respect to security concerns the hard disk can be removed from the instrument, but
it is bound to the specific R&S SMBV. Therefore it cannot be changed between different
instruments.
NOTICE! Risk of instrument damage and data loss!. During operation the instrument is
accessing the hard disk. Removing the hard disk while operating will lead to data loss or
even instrument damage.
Do not remove the hard disk during operation.
Rear Panel Tour
To Next Page
Loading...
