Remote Control Commands
R&S
®
SMBV100A
538Operating Manual 1407.6062.32 ─ 08
Example:
BB:ARB:WAV:POINt?
queries the number of I/Q values pairs in the waveform file.
Response: 401
the waveform file contains 401 I/Q values pairs.
Usage: Query only
[:SOURce<hw>]:BB:ARB:WAVeform:SELect <Filename>
The command selects the waveform file. If the file is not on the default path, the path
must be specified at the same time. If no file of the specified name exists, it is created.
The file extension may be omitted. Only files with the file extension *.wv will be created
or loaded.
Parameters:
<Filename> string
Example:
BB:ARB:WAV:SEL '/var/smbv/user/wave1.wv'
selects waveform file 'wave1.wv' from the /var/smbv/user directory
and loads it..
BB:ARB:TRIG:SEQ AAUT
sets trigger mode Armed_Auto.
BB:ARB:TRIG:SOUR INT
selects internal triggering.
BB:ARB:STAT ON
switches on the ARB generator.
BB:ARB:TRIG:EXEC
starts generating the selected waveform.
[:SOURce<hw>]:BB:ARB:WAVeform:TAG?
The commandqueries the content of the specified tag of the selected Waveform file file
(see chapter 7.3, "R&S Signal Generator Waveform and List Format", on page 439).
Return values:
<Tag> string
Example:
BB:ARB:WAV:TAG? 'comment'
queries the content of the 'comment' tag.
Response: "Sine wave for test purposes"
Usage: Query only
SOURce:BB:ARB:WSEG Subsystem
The WSEGment subsystem contains the commands for setting the Multi Segment Wave-
form Generator.
Section chapter 7.3, "R&S Signal Generator Waveform and List Format", on page 439
describes the ARB waveform format and how it is used to transmit waveforms via the IEC
bus.
[:SOURce<hw>]:BB:ARB:WSEGment..............................................................................539
SOURce Subsystem
To Next Page
Loading...
