Rohde & Schwarz SMBV100A - Source:iq:output Subsystem

Remote Control Commands
R&S
®
SMBV100A
640Operating Manual 1407.6062.32 ─ 08
[:SOURce<hw>]:IQ:SWAP[:STATe] <State>
When set to ON, this command swaps the I and Q channel.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: OFF
Example:
IQ:SWAP ON
swaps the I and Q channel.
[:
SOURce<hw>]:IQ:WBSTate <Wbstate>
This command selects optimized setting for wideband modulation signals (>5 MHz)
(State ON).
Parameters:
<Wbstate> 0 | 1 | OFF | ON
*RST: OFF
Example:
IQ:WBST ON
activates optimized setting for wideband signals.
7.14.10 SOURce:IQ:OUTput Subsystem
7.14.10.1 Analog I/Q Outputs
This subsystem contains the commands for configuring the differential output.
For information about the required options, see chapter 5.6.3.2, "Analog I/Q Out-
put", on page 265.
[:SOURce<hw>]:IQ:OUTPut:BIAS:OPTimization[:RF]:STATe.............................................640
[:SOURce<hw>]:IQ:OUTPut:LEVel..................................................................................641
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:POWer:PEP..........................................................641
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:POWer:PEP:RESult...............................................641
[:SOURce<hw>]:IQ:OUTPut:MODE.................................................................................641
[:SOURce<hw>]:IQ:OUTPut:POWer:DATTenuation...........................................................642
[:SOURce<hw>]:IQ:OUTPut:TYPE...................................................................................642
[:SOURce<hw>]:IQ:OUTPut:BIAS:OPTimization[:RF]:STATe <State>
This command activates/deactivates optimization of level accuracy and imbalance for RF
Output. Level accuracy and imbalance can be either optimized for RF output (active) or
for differential outputs (not active).
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
SOURce Subsystem