Rohde & Schwarz SMBV100A - I;Q Modulation - I;Q Mod Block

Instrument Function
R&S
®
SMBV100A
235Operating Manual 1407.6062.32 ─ 08
Range
Sets the range for filling the table.
SCPI command:
n.a.
Select column to fill
Selects either the frequency or the level column to be filled with the value defined below.
SCPI command:
n.a.
Start value
Sets the start value for the frequency or the level entries.
SCPI command:
n.a.
End value
Sets the end value for the frequency or the level entries.
SCPI command:
n.a.
Increment value
Sets the increment for the frequency or the level entries.
SCPI command:
n.a.
Fill
Fills the selected column in the set range with values, starting with the start value and
using the set increment.
SCPI command:
n.a.
5.5 I/Q Modulation - I/Q Mod Block
The R&S Signal Generator offers I/Q modulation with:
●
external analog I/Q signals,
●
external digital signals,
●
internal digital signals.
Either the external analog signal or the externally or internally generated baseband signal
is fed into the I/Q modulator ("I/Q Mod" function block).
I/Q Modulation - I/Q Mod Block