Rohde & Schwarz SMBV100A - Common Settings;[: S Ource<Hw>]: B B: a Rb: P Reset; Common Settings; Source:bb:arb Subsystem; [: S Ource<Hw>]: B B: a RB: P Reset

Remote Control Commands
R&S
®
SMBV100A
505Operating Manual 1407.6062.32 ─ 08
[:SOURce<hw>]:BB:POFFset <POffset>
The command sets the relative phase offset of the baseband signal.
The phase offset affects the signal on the "baseband block" output.
Parameters:
<POffset> float
Range: 0 to 359.9
Increment: 0.01
*RST: 0
Default unit: DEG
Example:
BB:POFF 0.5DEG
sets a relative phase offset of 0.5 DEG for the baseband signal
7.14.3.2 SOURce:BB:ARB Subsystem
The ARB subsystem contains the commands for setting the ARB Generator. Settings for
clock and trigger interfaces and for external outputs are entered in the SOURce:INPut
and SOURce:OUTput subsystems.
Section chapter 7.3, "R&S Signal Generator Waveform and List Format", on page 439
describes the ARB waveform format and how it is used to transmit waveforms via the IEC
bus.
● Common Settings..................................................................................................505
● Clock Settings.......................................................................................................506
● Trigger Settings.....................................................................................................508
● Marker Settings.....................................................................................................515
● Test Signals Settings............................................................................................518
● SOURce:BB:ARB:MCAR Subsystem...................................................................521
● SOURce:BB:ARB:WAV Subsystem......................................................................535
● SOURce:BB:ARB:WSEG Subsystem...................................................................538
Common Settings
[:SOURce<hw>]:BB:ARB:PRESet....................................................................................505
[:SOURce<hw>]:BB:ARB:STATe.....................................................................................505
[:SOURce<hw>]:BB:ARB:PRESet
The command sets all ARB generator parameters to their default values.
Example:
BB:ARB:PRES
resets the ARB generator to default values.
Usage: Event
[:SOURce<hw>]:BB:ARB:STATe <State>
The command enables the ARB generator. Any other standards or digital modulation that
may be in the ON state are automatically turned OFF.
SOURce Subsystem