Rohde & Schwarz SMBV100A - 7 Remote Control Commands; Cal; Cls

Remote Control Commands
R&S
®
SMBV100A
433Operating Manual 1407.6062.32 ─ 08
7 Remote Control Commands
In the following, all remote-control commands will be presented in detail with their param-
eters and the ranges of numerical values.
For an introduction to remote control and the status registers, refer to chapter 6, "Remote
Control Basics", on page 392.
7.1 Common Commands
Common commands are described in the IEEE 488.2 (IEC 625-2) standard. These com-
mands have the same effect and are employed in the same way on different devices.
The headers of these commands consist of "*" followed by three letters. Many common
commands are related to the Status Reporting System.
Available common commands:
*CAL.............................................................................................................................433
*CLS.............................................................................................................................433
*ESE.............................................................................................................................434
*ESR............................................................................................................................434
*IDN.............................................................................................................................434
*IST..............................................................................................................................434
*OPC............................................................................................................................435
*OPT............................................................................................................................435
*PCB............................................................................................................................435
*PRE............................................................................................................................435
*PSC............................................................................................................................435
*RCL.............................................................................................................................436
*RST.............................................................................................................................436
*SAV.............................................................................................................................436
*SRE............................................................................................................................436
*STB.............................................................................................................................437
*TRG............................................................................................................................437
*TST.............................................................................................................................437
*WAI.............................................................................................................................437
*CAL?
Calibration Query
Initiates a calibration of the instrument and subsequently queries the calibration status.
Responses > 0 indicate errors.
Usage:
Query only
*CLS
CLear Status
Common Commands