Rohde & Schwarz SMBV100A - [: S Ource<Hw>]: L IST: I Ndex: S Tart; [: S Ource<Hw>]: L IST: I Ndex: S TOP

Remote Control Commands
R&S
®
SMBV100A
665Operating Manual 1407.6062.32 ─ 08
Example:
LIST:SEL '/var/smbv/Lists/Listmode/list3'
selects list3 for use in List mode.
FREQ:MODE LIST
activates List mode. List3 is processed.
LIST:MODE STEP
selects manual, step-by-step processing of the list.
LIST:IND 5
the frequency/level value pair with index 5 is executed.
TRIG:LIST:SOUR SING
selects triggering by means of the single trigger. The list is exe-
cuted once.
SOUR:LIST:TRIG:EXEC
triggers the processing of the selected list.
[:SOURce<hw>]:LIST:INDex:STARt <Start>
The command sets the start index of the index range which defines a subgroup of fre-
quency/level value pairs in the current list. Only the values in the set index range
(:LIST:INDex:STARt ... :LIST:INDex:STOP) are processed in List mode.
Parameters:
<Start> float
Range: 0 to list length
*RST: 0
Example:
LIST:SEL '/var/smbv/Lists/Listmode/list3'
selects list3 for use in List mode.
LIST:IND:STAR 25
sets 25 as start index of the index range.
LIST:IND:STOP 49
sets 49 as stop index of the index range.
FREQ:MODE LIST
activates List mode. The frequency/level value pairs from index 25
to index 49 in list3 are processed. All other entries of the list are
ignored.
[:SOURce<hw>]:LIST:INDex:STOP <Stop>
The command sets the stop index of the index range which defines a subgroup of fre-
quency/level value pairs in the current list. Only the values in the set index range
(:LIST:INDex:STARt ... :LIST:INDex:STOP) are processed in List mode.
Parameters:
<Stop> float
Range: 0 to list length
*RST: 0
SOURce Subsystem