Rohde & Schwarz SMBV100A - Example of Setup

Getting Started
R&S
®
SMBV100A
56Operating Manual 1407.6062.32 ─ 08
3.4 Example of Setup
This section provides an example on how to configure the instrument to generate and
display a simple QPSK-modulated signal.
Configuring and displaying a QPSK-modulated signal
To generate and display a QPSK-modulated signal, proceed as follow:
1. Activate default (preset) state.
Press the PRESET key to set a defined instrument state.
2. Select and activate digital modulation
a) Turn the rotary knob and select the "Baseband A" block.
Example of Setup