Instrument Function
R&S
®
SMBV100A
202Operating Manual 1407.6062.32 ─ 08
vidual modulation menus (e.g. "Amplitude Modulation" menu). These settings affect all
modulations which use the same modulation sources and the LF output.
LF Output Dialog
State - LF Output
Activates/deactivates the LF output. This setting has no effect on the modulations.
The modulation signal is output at the LF OUTPUT connector of the instrument.
SCPI command:
[:SOURce]:LFOutput[:STATe] on page 651
Output Voltage - LF Output
Sets the output voltage of the LF output. The entered value determines the peak voltage.
SCPI command:
[:SOURce]:LFOutput:VOLTage on page 655
LF Gen Frequency
Sets the frequency of the LF generator.
This setting affects all analog modulations which use the LF generator as the internal
modulation source.
SCPI command:
[:SOURce]:LFOutput:FREQuency on page 648
LF Gen Shape
Selects the waveform shape of the LF signal.
SCPI command:
[:SOURce]:LFOutput<ch>:SHAPe on page 655
LF Source Impedance
Selects the output impedance of the LF generator. Selection LOW and 600 Ohm are
available.
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
