Rohde & Schwarz SMBV100A - Page 536

Remote Control Commands
R&S
®
SMBV100A
519Operating Manual 1407.6062.32 ─ 08
Example:
BB:ARB:TSIG:SINE:CRE:NAM 'sine_test'
generates a test sine signal and saves it into the wavefile
sine_test.
Usage: Setting only
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:I <I>
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:Q <TSig>
Sets the value for the Q component of the test signal
Parameters:
<TSig> float
Range: -0.5 to 0.5
Increment: 0.001
*RST: 0
Default unit: FS
Example:
BB:ARB:TSIG:CIQ:Q 0.5
sets the value for the Q component of the test signal.
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:AMPLitude <Amplitude>
Sets the digital amplitude of the rectangular wave.
Parameters:
<Amplitude> float
Range: 0 to 1
Increment: 0.001
*RST: 0.800
Default unit: FS
Example:
BB:ARB:TSIG:RECT:AMPL 0.5
sets the amplitude of the test signal
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:FREQuency <Frequency>
The command sets the frequency of the test signal.
Parameters:
<Frequency> float
Range: 100 Hz to 25.0E6 Hz
Increment: 0.01
*RST: 1 kHz
Example:
BB:ARB:TSIG:RECT:FREQ 100 kHz
sets the frequency of the test signal of 100 kHz.
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:OFFSet <Offset>
Sets the DC component.
SOURce Subsystem