Remote Control Commands
R&S
®
SMBV100A
704Operating Manual 1407.6062.32 ─ 08
STATus:QUEStionable:CONDition? <Condition >
The command queries the content of the CONDition part of the STATus:QUEStionable
register. This part contains information on the action currently being performed in the
instrument. The content is not deleted after being read out since it indicates the current
hardware status.
Parameters:
<Condition > string
Example:
STAT:OPER:COND
queries the Status:Questionable:Condition register.
Usage: Query only
SCPI confirmed
STATus:
QUEStionable:ENABle <Enable>
The command sets the bits of the ENABle part of the STATus:QUEStionable register.
This setting determines which events of the Status-Event part are enabled for the sum
bit in the status byte. These events can be used for a service request.
Parameters:
<Enable> string
Example:
STAT:OPER:ENAB 1
problems when performing an adjustment cause an entry to be
made in the sum bit.
Usage: SCPI confirmed
STATus:QUEStionable[:EVENt]? <EVENt>
The command queries the content of the EVENt part of the STATus:QUEStionable
register. This part contains information on the actions performed in the instrument since
the last readout. The content of the EVENt part is deleted after being read out.
Parameters:
<EVENt> string
Example:
STAT:QUES:EVEN?
queries the Status:Questionable:Event register.
Usage: Query only
SCPI confirmed
STATus:QUEStionable:NTRansition <Ntransition>
The command sets the bits of the NTRansition part of the STATus:QUEStionable register.
If a bit is set, a transition from 1 to 0 in the condition part causes an entry to be made in
the EVENt part of the register.
STATus Subsystem
To Next Page
Loading...
