Remote Control Commands
R&S
®
SMBV100A
585Operating Manual 1407.6062.32 ─ 08
Parameters:
<Mode> AUTO | FULL | USER
AUTO
The resolution is set to an optimum value on the basis of the signal
and display type.
FULL
The resolution is set such that the display covers the entire signal
bandwidth.
USER
with the command SOUR:BB:GRAP:SRAT:USER, the user can
determine the resolution by setting the signal bandwidth for which
the display is to be generated
*RST:
AUTO
Example:
BB:GRAP:SRAT:MODE FULL
sets the sample rate mode.
[:SOURce<hw>]:BB:GRAPhics:SRATe:USER <User>
(Enabled for BB:GRAPH:SRAT:MODE USER)
Selects the signal bandwidth for which the display is to be generated. The setting range
moves between the minimum and maximum bandwidth which is possible for the selected
display. The selection is made graphically by moving the pointer.
Parameters:
<User> float
Range: 0.1 to 100
Increment: 0.1
*RST: 10
Default unit: PCT
Example:
BB:GRAP:SRAT:MODE USER
sets the sample rate mode.
Example:
BB:GRAP:SRAT:USER 20
sets the sample rate factor.
[:SOURce<hw>]:BB:GRAPhics:STATe <State>
Activates/deactivates the selected graphical display.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
BB:GRAP:STAT ON
activates the graphical graphics.
SOURce Subsystem
To Next Page
Loading...
