Remote Control Commands
R&S
®
SMBV100A
481Operating Manual 1407.6062.32 ─ 08
:MMEMory:LOAD:STATe <sav_rcl_state_number>, <file_name>
This command loads the specified file stored under the specified name in an internal
memory.
After the file has been loaded, the instrument setting must be activated using an *RCL
command.
Setting parameters:
<sav_rcl_state_number>Determines to the specific <number> to be used with the *RCL
command, e.g. *RCL 4.
<file_name> String parameter to specify the file name with extension
*.savrcltxt.
Example:
See "Storing and Loading Current Settings" on page 476.
Usage: Setting only
:MMEMory:MDIRectory <directory_name>
Creates a new subdirectory for mass memory storage in the specified directory. If no
directory is specified, a subdirectory is created in the default directory. This command
can also be used to create a directory tree.
Setting parameters:
<directory_name> string
String parameter to specify the new directory.
Example:
See "Working with Files and Directories" on page 476.
Usage: Setting only
:MMEMory:MOVE <file_source>, <file_destination>
Moves an existing file to a new location or, if no path is specified, renames an existing
file.
It is also possible to specify the path using another parameter. The command is:
MMEMory:MOVE
file_source,msus_source[, file_destination, msus_destination]
Setting parameters:
<file_source> String parameter to specify the name of the file to be moved.
<file_destination> String parameters to specify the name of the new file.
Example:
See "Working with Files and Directories" on page 476.
Usage: Setting only
SCPI confirmed
MMEMory Subsystem
To Next Page
Loading...
