Instrument Function
R&S
®
SMBV100A
210Operating Manual 1407.6062.32 ─ 08
RF Frequency Sweep Settings
State - Frequency Sweep
Activates/deactivates RF sweep mode.
Note: Activating the RF-Sweep mode automatically disables other sweep modes, and
the list mode.
SCPI command:
[:SOURce<hw>]:FREQuency:MODE on page 630
Mode - Frequency Sweep
Selects the sweep instrument operating mode and the sweep mode.
"Auto"
Sets an automatic repeated sweep cycle. If a different sweep mode was
activated prior to the "Auto" mode, the cycle continues from the current
sweep setting.
The "Reset Sweep" button resets the sweep to the start frequency.
Example:
SOUR:SWE:FREQ:MODE AUTO
TRIG:FSW:SOUR AUTO
SOUR:FREQ:MODE SWE
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
