Instrument Function
R&S
®
SMBV100A
222Operating Manual 1407.6062.32 ─ 08
In the top section, the LF Sweep mode is activated and the sweep mode is selected. The
buttons are used to reset the LF sweep (all sweep modes) or to execute the LF sweep
("Single" mode).
The sweep range, sweep spacing and dwell time are set in the bottom of the section.
State - LF Sweep
Activates LF Sweep mode.
Note: Activating the LF frequency sweep automatically deactivates the list mode, RF
level sweep and RF frequency sweep.
SCPI command:
[:SOURce]:LFOutput:FREQuency:MODE on page 649
Mode - LF Sweep
Selects the Sweep instrument operating mode and Sweep mode.
"Auto"
Sets are automatic repeated sweep cycle. If a different sweep mode
was activated prior to the "Auto" mode, the cycle continues from the
current sweep setting.
The "Reset Sweep" button resets the sweep to the start frequency.
Example:
SOUR:LFO:SWE:FREQ:MODE AUTO
TRIG0:SWE:SOUR AUTO
SOUR:LFO:FREQ:MODE SWE
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
