Instrument Function
R&S
®
SMBV100A
233Operating Manual 1407.6062.32 ─ 08
Externally edited Excel tables with frequency/level pairs can be imported as text or CSV-
files and used for list mode.
On the other hand, internally created list mode lists can be exported as text or CSV-files.
Mode - List Mode
Selects if list mode lists should be imported or exported. The settings offered below
depend on the selected mode.
SCPI command:
[:SOURce<hw>]:LIST:DEXChange:MODE on page 662
Extension - List Mode
Selects the file extension of the ASCII file to be imported or exported. Selection TXT (text
file) or CSV (Excel file) is available.
SCPI command:
[:SOURce<hw>]:LIST:DEXChange:AFILe:EXTension on page 659
Decimal Point - List Mode
Selects the decimal separator used in the ASCII data between '.' (decimal point) and ','
(comma) with floating-point numerals.
SCPI command:
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:DECimal on page 661
Column Separator- List Mode
Selects the separator between the frequency and level column of the ASCII table.
SCPI command:
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:COLumn on page 660
Select ASCII Source / Destination - List Mode
Calls the "File Manager" for selecting the ASCII file to be imported into a list mode list
(source) or the ASCII file the list mode list is exported (destination) in.
SCPI command:
[:SOURce<hw>]:LIST:DEXChange:AFILe:SELect on page 660
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
