Instrument Function
R&S
®
SMBV100A
309Operating Manual 1407.6062.32 ─ 08
In the "Select Ramp to Edit" section the signal characteristics are graphically displayed.
The scaling of the x-axis is always adapted to the overall length of the control list to provide
constant overview of all defined ramps.
The ramps can be assigned the exact bit position in the signal by means of
●
The bit scale below the marker/control signal characteristic.
●
The display of the current cursor position in the "Cursor" menu section if the cursor
marks the ramp.
The ramps can be set either graphically in the "Select Ramp to Edit" section or in the
table of the "Positions <Signal>" section in the lower right corner. To make the setting
easy, a selection of preset ramp characteristics is offered in the "Preset Ramp <Sig-
nal>" section.
Edit Control List
The configuration of the currently selected control list is displayed. This list is either
selected in the "File Select" menu ("List Management "submenu by means of the "Control
List... "button) or via the remote-control command.
SCPI command:
[:SOURce<hw>]:BB:DM:CLISt:SELect on page 576
[:SOURce<hw>]:BB:DM:CLISt:DATA on page 575
Configure Control Signal - Digital Modulation
Displays the colour the marker/control signal has been assigned.
Displays whether the "CList" marker type has been selected in the Trigger/Marker/Clock
menu for this marker.
Displays whether the "Internal" source has been selected for this control signal in the
individual setting menu.
Baseband Signal - Baseband Block
To Next Page
Loading...
