Instrument Function
R&S
®
SMBV100A
311Operating Manual 1407.6062.32 ─ 08
"Ramp Up"
The marker/control signal contains a ramp from low to high. The ramp
is shifted to the center of the displayed signal area and can subse-
quently be shifted as required.
"Ramp Down"
The marker/control signal contains a ramp from high to low. The ramp
is shifted to the center of the displayed signal area and can subse-
quently be shifted as required.
"Ramp Up/
Down"
The marker/control signal contains a ramp from low to high and from
high to low. The ramps are symmetrically shifted around the center of
the displayed signal area and can subsequently be shifted as required.
"Ramp Down/
Up"
The marker/control signal contains a ramp from high to low and from
low to high. The ramps are symmetrically shifted around the center of
the displayed signal area and can subsequently be shifted as required.
SCPI command:
n.a.
Cursor Position - Digital Modulation
Enters the cursor position.
In the graphic display, the cursor is positioned according to the entry.
Vice versa, graphically shifting the cursor will change the displayed value.
If the entered value exceeds the selected length of the definition range, the length is
adjusted automatically.
SCPI command:
n.a.
Positions Control Signal - Digital Modulation
Opens table by using the "Edit Table .. "button.
The ramps of the selected signal can be edited in the table. When the table is opened,
the current configuration of the selected marker/control signal is displayed.
The bit position is specified in the "Ramp Position" column, the high or low signal status
in the "Ramp State" column. At the end of the list, there is always a blank row for entering
new values.
The changes are accepted in the graphic display after pressing the "Accept" button.
SCPI command:
n.a.
Baseband Signal - Baseband Block
To Next Page
Loading...
