Instrument Function
R&S
®
SMBV100A
337Operating Manual 1407.6062.32 ─ 08
The following figure shows an example of the transition from a sinewave signal seg-
ment to a sawtooth segment (I channel, above) in the case of next segment external
triggering (below).
●
When "Next Segment" Seamless is selected and a new segment trigger event occurs,
the new segment is not output until the whole of the current segment has been output
(wrap around). In this case the signal transition is seamless. As a prerequisite for a
seamless switchover, all segments must have the same sample rate.
The following figure shows an example of the seamless transition from a sinewave
signal segment to a sawtooth segment (I channel, above) in the case of next segment
external triggering (below).
The regular trigger mode for starting the waveform generation and triggering the whole
multi segment sequence is set with the parameters in the "Trigger In" section of the
"Trigger/Marker/Clock" dialog.
Baseband Signal - Baseband Block
To Next Page
Loading...
