Instrument Function
R&S
®
SMBV100A
372Operating Manual 1407.6062.32 ─ 08
Parameter Value
Desired Crest Factor 3 dB
Trigger
Mode Auto
Source Internal
Ext. Delay 0
Ext. Inhibit 0
Marker
Channel 1...4 Restart
Clock
Source Internal
Multi Channel Setup
Start Carrier 0
Stop Carrier 0
State ON
Power 0 dB
Power Step 0 dB
Initial Phase 0°
Phase Step 0°
Channel Setup
State ON
Phase 0°
Power 0 dB
SCPI command:
[:SOURce<hw>]:BB:MCCW:PRESet on page 590
Carrier Setup
The "Carrier Setup" section is used to configure the Multi Carrier CW.
Number of Carriers
Sets the number of carriers for the Multi Carrier CW signal.
By default the multi carrier table already lists 64 carriers that are preset to the settings
State = ON, Power = 0 dB, Phase = 0°.
Baseband Signal - Baseband Block
To Next Page
Loading...
