Instrument Function
R&S
®
SMBV100A
381Operating Manual 1407.6062.32 ─ 08
"Off"
The signal output begins after elapsing of the processing time and starts
with sample 0, i.e. the complete signal is outputted.
This mode is recommended for triggering of short signal sequences
with signal duration comparable with the processing time of the instru-
ment.
SCPI command:
[:SOURce<hw>]:BB:MCCW:TRIGger:EXTernal:SYNChronize:OUTPut
on page 600
Trigger Delay
Sets the trigger signal delay in samples on external triggering or on internal triggering via
the second path.
Sets the trigger signal delay in samples on external triggering.
This enables the R&S Signal Generator to be synchronized with the device under test or
other external devices.
SCPI command:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:DELay on page 602
Trigger Inhibit
Sets the duration for inhibiting a new trigger event subsequent to triggering. The input is
to be expressed in samples.
In the "Retrigger" mode, every trigger signal causes signal generation to restart. This
restart is inhibited for the specified number of samples.
This parameter is only available on external triggering.
SCPI command:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:INHibit on page 602
Marker Mode
The marker output signal for synchronizing external instruments is configured in the
marker settings section "Marker Mode".
The R&S SMBV supports only two markers.
Marker Mode
Selects a marker signal for the associated "MARKER" output.
"Restart"
A marker signal is generated at the start of the waveform.
Baseband Signal - Baseband Block
To Next Page
Loading...
