Remote Control Commands
R&S
®
SMBV100A
446Operating Manual 1407.6062.32 ─ 08
At 50 Ohm between the inner and outer conductors of the I and Q outputs, an amplitude
Vp of +/-0.5 Volt arises on the I/Q output connectors of the R&S SMBV. The illustration
also applies to the Q output.
Setting parameters:
Length Specifies the number of bytes in a WAVEFORM tag and is calculated
as follow:
Length = Number of I/Q pairs * 4 (i.e. 2 bytes per I and
2 bytes per Q value) + 1 byte (i.e. the length of the #).
R&S Signal Generator Waveform and List Format
To Next Page
Loading...
