Remote Control Commands
R&S
®
SMBV100A
516Operating Manual 1407.6062.32 ─ 08
Parameters:
<Mode> UNCHanged | RESTart | PULSe | PATTern | RATio
UNCHanged
A marker signal as defined in the waveform file (tag 'marker mode
x') is generated.
RESTart
A marker signal is generated at every waveform start.
PULSe
A pulsed marker signal is generated. The pulse frequency (= sym-
bol rate/divider) is defined with the
SOUR:BB:ARB:TRIG:OUTP:PULS:DIV command and can be
queried with the SOUR:BB:ARB:TRIG:OUTP:PULS:FREQ?
command.
PATTern
A marker signal is generated with the aid of a user-definable bit
pattern. The bit pattern is entered with the aid of com-
mand :BB:ARB:TRIGger:OUTPut:PATTern. The bit pattern is
a maximum of 32 bits long.
RATio
A regular marker signal corresponding to the Time Off / Time On
specifications in the com-
mands :ARB:TRIGger:OUTPut:OFFTime
and :ARB:TRIGger:OUTPut:ONTime is generated.
*RST:
UNCHanged
Example:
BB:ARB:TRIG:OUTP2:MODE PULS
selects the pulsed marker signal on output MARKER 2.
BB:ARB:TRIG:OUTP2:STAT ON
activates the pulsed marker signal on output MARKER 2.
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:OFFTime <OffTime>
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:ONTime <OnTime>
The command sets the number of samples in a period (ON time + OFF time) during which
the marker signal in setting :ARB:TRIGger:OUTPut:MODE RATio on the marker out-
puts is ON.
Parameters:
<OnTime> float
Range: 1 to 14913079
*RST: 1
Example:
BB:ARB:TRIG:OUTP2:ONT 20
sets an ON time of 20 samples for marker 2
SOURce Subsystem
To Next Page
Loading...
