Rohde & Schwarz SMBV100A - Page 542

Remote Control Commands
R&S
®
SMBV100A
525Operating Manual 1407.6062.32 ─ 08
[:SOURce<hw>]:BB:ARB:MCARrier:CARRier<ch>:PHASe <Phase>
The command sets the start phase of the selected carrier.
The phase settings are only valid if optimization of the crest factor is disabled
(:SOURce:BB:ARB:MCARrier:CFACtor:MODE OFF).
Parameters:
<Phase> float
Range: 0 to 359.99
Increment: 0.01
*RST: 0
Default unit: DEG
Example:
BB:ARB:MCAR:CARR15:PHAS 90 DEG
sets a start phase of 90° for carrier 15.
[:
SOURce<hw>]:BB:ARB:MCARrier:CARRier<ch>:POWer <Power>
The command sets the gain of the selected carrier.
Parameters:
<Power> float
Range: -80 to 0
Increment: 0.01
*RST: 0
Default unit: dB
Example:
BB:ARB:MCAR:CARR15:POW -50 dB
sets the power of carrier 15 to -50 dB.
[:SOURce<hw>]:BB:ARB:MCARrier:CARRier<ch>:STATe <State>
The command switches the selected carrier on or off.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: ON
Example:
BB:ARB:MCAR:CARR15:STAT ON
switches carrier 15 on.
[:SOURce<hw>]:BB:ARB:MCARrier:CFACtor:MODE <Mode>
The command sets the mode for optimizing the crest factor by calculating the carrier
phases.
SOURce Subsystem