Remote Control Commands
R&S
®
SMBV100A
578Operating Manual 1407.6062.32 ─ 08
Example:
BB:DM:DLIS:SEL ' d_list2'
selects data list d_list2.
FORM ASC
selects ASCII data transmission format.
BB:DM:DLIS:DATA:APP 1,1,1,0,0,0,1,1,0,1...
adds the specified numeric data to the existing data in data list
d_list2.
Usage: Setting only
[:SOURce<hw>]:BB:DM:DLISt:DELete <Filename>
The command deletes the specified data list. from the default directory. The default
directory is set using command MMEM:CDIRectory. A path can also be specified, in
which case the files in the specified directory are deleted. The file extension may be
omitted. Only files with the file extension *.dm_iqd will be deleted.
Setting parameters:
<Filename> string
Example:
BB:DM:DLIS:DEL ' d_list2'
deletes data list d_list2.
Usage: Setting only
[:SOURce<hw>]:BB:DM:DLISt:POINts <Points>
The command defines the number of bits in the selected data list to be utilized. When a
list is being filled with block data, this data is only ever sent in multiples of 8 bits. However
the exact number of bits to be exploited can be set to a different figure. The superfluous
bits in the list are then ignored.
Parameters:
<Points> integer
Range: 0 to INT_MAX
Increment: 1
*RST: 0
Example:
BB:DM:DLIS:POIN 234
defines the number of bits in the data list to be utilized as 234 bits.
If the list was filled with block data, at least the last 6 bits will be
ignored.
[:SOURce<hw>]:BB:DM:DLISt:SELect <Select>
The command selects the data list in the default directory. The default directory is set
using command MMEM:CDIRectory. A path can also be specified, in which case the
files in the specified directory are selected. If a data list with the specified name does not
yet exist, it is created. The file extension may be omitted. Only files with the file extension
*.dm_iqd will be selected or created.
SOURce Subsystem
To Next Page
Loading...
