Remote Control Commands
R&S
®
SMBV100A
594Operating Manual 1407.6062.32 ─ 08
The maximum carrier spacing is automatically reduced so that the maximum total band-
width is not exceeded on entering the number of carriers
(:BB:MCCW:CARRier:COUNt).
Parameters:
<Spacing> float
Range: 0 to 120E6
Increment: 0.01
*RST: 10E3
Example:
BB:MCCW:CARR:SPAC 10 MHz
sets a carrier spacing of 10 MHz.
[:
SOURce<hw>]:BB:MCCW:CARRier:STATe <State>
The command switches the selected carrier on or off.
The counting in remote control differs from the numbers in the carrier table. Index 0 cor-
responds to number 1 (first line) in the table. Therefore, switching the state of the channel
via remote control always switches the state of <channel index> + 1 in the table.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
BB:MCCW:CARR:STAT 15, ON
switches carrier 16 on.
[:SOURce<hw>]:BB:MCCW:CFACtor <CFactor>
The command sets the desired crest factor for the multi carrier signal on selection of the
command SOUR:BB:MCCW:CFAC:MODE SLOW.
Parameters:
<CFactor> float
Range: 0 to 30
Increment: 0.01
*RST: 3
Example:
BB:MCCW:CFAC:MODE SLOW
sets the Target Crest optimization mode.
BB:MCCW:CFAC 10 dB
sets the desired crest factor to 10 dB.
[:SOURce<hw>]:BB:MCCW:CFACtor:ACTual?
Queries the actual Crest Factor for BB:MCCW:CFAC:MODE SLOW.
SOURce Subsystem
To Next Page
Loading...
