Preparing for Use
R&S
®
SMBV100A
45Operating Manual 1407.6062.32 ─ 08
5. Set up the VNC connection between the instrument and:
a)
the remote computer with Linux/Unix operating system, see "Setting up the VNC
connection on the Linux/Unix remote computer" on page 47;
b)
the remote computer with Windows operating system, see "Setting up the VNC
connection on the Windows remote computer" on page 48.
Enabled Direct Control
The direct control of the instrument is not disabled and the instrument can be controlled
from the front panel and via the remote computer alternately.
Installing the Ultr@VNC application
1. Download the program from the internet and copy it to a directory that can be
accessed.
2. On the instrument, shut down firmware using the ALT+F4 key combination.
3. Double click on the setup file to start the installation.
The setup wizard leads through the installation. This description focus only on the
relevant settings.
a) Select installation of all components.
Remote Access via an External Controller
To Next Page
Loading...
