Rohde & Schwarz SMBV100A - Page 725

Remote Control Commands
R&S
®
SMBV100A
708Operating Manual 1407.6062.32 ─ 08
Example:
SYST:COMM:NETW:COMM:DOM ABC.DE
enters the domain of the network.
:SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname <Hostname>
The command enters the individual computer name of the R&S Signal Generator. The
entry is only activated after sending command SYST:COMM:NETW:COMM:SET.
Note: The hostname can only be changed after deactivating protection level 1 (command
SYSTem:PROTect<n>:STATe OFF, password)
Parameters:
<Hostname> string
Example:
SYST:COMM:NETW:HOST ‘SIGGEN’
enters the individual computer name of the R&S Signal Generator.
Example:
SYST:COMM:NETW:COMM:SET ON
activates the change of the hostname.
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup <Workgroup>
The command enters the individual workgroup name of the instrument.
Parameters:
<Workgroup> string
Example:
SYST:COMM:NETW:COMM:WORK 'TEST_09'
enters the workgroup name 'TEST_09'.
:SYSTem:COMMunicate:NETWork:IPADdress:MODE <Mode>
The command selects if the IP address is assigned automatically or manually. The entry
is only activated after sending command SYST:COMM:NETW:IPAD:SET.
Parameters:
<Mode> AUTO | STATic
AUTO
The IP address is assigned automatically. The network used must
support automatic assignment of address (DHCP) in order to use
this function.
STATic
The IP address is assigned manually.
*RST: AUTO
Example:
SYST:COMM:NETW:IPAD:MODE AUTO
the IP address is assigned automatically (DHCP).
SYST:COMM:NETW:IPAD:SET ON
activates DHCP.
SYSTem Subsystem