Rohde & Schwarz SMBV100A - Page 727

Remote Control Commands
R&S
®
SMBV100A
710Operating Manual 1407.6062.32 ─ 08
Example:
SYST:COMM:NETW:RES
queries the VISA resource string.
Response: TCPIP::192.1.2.3::INSTR
:SYSTem:COMMunicate:USB:RESource?
The command queries the visa resource string for remote control via the USB interface.
Return values:
<Resource> string
Example:
SYST:COMM:USB:RES?
queries the VISA resource string for remote control via the USB
interface.
Response: USB::72::000000::INSTR
Usage: Query only
:
SYSTem:COMMunicate:GPIB:RESource?
The command queries the visa resource string for remote control via the GPIB interface.
This string is used for remote control of the instrument.
To change the GPIB address, use the command SYST:COMM:GPIB:ADDR.
Return values:
<Resource> string
Example:
SYST:COMM:GPIB:RES
queries the VISA resource string.
Response: GPIB::28::INSTR
Usage: Query only
:SYSTem:COMMunicate:SERial:RESource?
The command queries the visa resource string for the serial remote control interface. This
string is used for remote control of the instrument.
Return values:
<Resource> string
Example:
SYST:COMM:SER:RES
queries the VISA resource string.
Response: ASRL1::INSTR
Usage: Query only
:SYSTem:COMMunicate:SERial:BAUD <Baud>
The command enters the baudrate for the serial remote control interface.
SYSTem Subsystem