Error Messages
R&S
®
SMBV100A
732Operating Manual 1407.6062.32 ─ 08
Error
Code
Error Description Remedy
182 Adjustment data miss-
ing
Adjustment data are missing. The adjustment data have to be
generated first by an internal or
external adjustment or to be loa-
ded into the instrument.
183 Adjustment data invalid Adjustment data are invalid and must
be restored.
The adjustment data have to be
generated again by an internal or
external adjustment or to be loa-
ded into the instrument.
200 Cannot access hard-
ware
The data transmission to a module was
unsuccessful.
The module is not installed, not
properly installed or missing.
201 Hardware revision out
of date
A later version of certain parts of the
instrument is necessary to execute the
function selected.
The driver does not support the
installed version of a module.
202 Cannot access the
EEPROM
A error occurs when writing or reading
a EEPROM.
The EEPROM might be defect
and has to be replaced.
203 Invalid EEPROM data Reading a EEPROM is possible, how-
ever the data are inconsistent.
204 Driver initialization
failed
Initialization of a driver fails when boot-
ing the instrument firmware.
The driver is not compatible with
the hardware or software configu-
ration of the instrument.
241 No current list There is no list selected. To execute
the required operation, a list has to be
selected in the related menu. If no list
is available, a new list must be created.
242 Unknown list type
specified
The list type selected is not valid for the
required operation.
For instance, the file extension for
waveform list files is *.wv. It is not pos-
sible to enter another file extension
when selecting a list.
Check the selected list type.
261 Waveform Protected The selected waveform file cannot be
transferred to a controller. The wave-
form is produced with simulation soft-
ware R&S WinIQSIM2 and is protec-
ted.
460 Cannot open file The selected file can not be opened. Check the path and file name.
461 Cannot write file The file can not be written. Check if the file is read-only.
462 Cannot read file The file can not be read. Check if the file contents are com-
patible with the file type.
463 Filename missing The required operation cannot be exe-
cuted because the file name is not
specified.
A file name has to be entered
when creating a new list.
Device-Specific Error Messages
To Next Page
Loading...
