Getting Started
R&S
®
SMBV100A
61Operating Manual 1407.6062.32 ─ 08
a) Press the FREQ key to activate the editing mode for frequency entry. The "Fre-
quency" entry field in the header section of the display is highlighted.
Enter the frequency using the numeric keypad and terminate the entry by press-
ing a unit key.
b) Press the LEVEL key and enter the level settings in the same way.
c) Press the DIAGRAM key to display the complete block diagram.
d) Turn the rotary knob to select the "RF/A Mod" block.
Press the TOGGLE ON/OFF key to activate the "RF/A Mod" block.
The QPSK modulation signal is now present at the RF output.
4. Select graphics display of I/Q signal
a) Turn the rotary knob to select the "Graphics" block and open the respective menu.
Example of Setup
To Next Page
Loading...
