Programming Tables
A-23
Root Numbers (Commands) by Number
12-8 55 Send Initial ID Message for Tx1
A-29 57 Select Access Mode (See table page A-29.)
7-36 60 Select Autopatch Call Types
7-6 61 Select Autopatch Dialing Mode
A-30 63 Enable/Disable Software Switches (See page A-30.)
7-53 64 Select Phone Line Answer Mode
7-25 65 Select Autopatch Timeout Timer
7-42 67 Enter/Clear Autopatch Reject Number Table
7-40 68 Enter/Clear Autopatch Accepted Number Table
7-48 69 Clear Autopatch Call Counter
15-2 70 Select Logic Outputs Latched ON
15-2 71 Select Logic Outputs Latched OFF
15-2 72 Select Logic Outputs Momentary ON
15-2 73 Select Logic Outputs Momentary OFF
7-57 79 Select Phone Line Off-Hook Timer
18-6 80 Select Repeater Anti-Kerchunk Key-Up Delay
7-26 81 Reset Autopatch Timeout Timer
11-7 82 Select DTMF Decoder Interdigit Timer
7-15 83 Dump Autopatch Using A Code
7-23 83 1 Landline Hookflash
7-34 83 2 Autopatch Go Off-Hook
7-34 83 3 Autopatch Go Off-Hook, Ignore Busy Logic Input
7-13 83 10 Select/Delete Autopatch Dialing Prefix
7-45 84 Autopatch Redial Last Number
7-46 85 Clear Autopatch Redialer
7-49 86 Send Autopatch Call Count in CW
7-60 87 Trigger Reverse Patch
7-61 88 Answer Reverse Patch
11-3 89 Select DTMF Priority/Scan
13-3 90 Select Audio Routing Priorities
7-68 91 Select Autopatch Command Response Message Routing
5-2 92 Assign Control Operator Password
5-3 93 Assign Master Password
5-4
5-5
94 Assign Control Operator Privilege level
11-8 96 Select DTMF Decoder Mute Delay
6-15 98 Pause Command Execution
A-29 99 Select xx.x Minute Timers (See table page A-29.)
To Next Page
Loading...