Schweitzer Engineering Laboratories SEL-311C - Displaying Metering Quantities on the Rotating Default Display; Table 7.10 Relay Setting Variables

7.43
Date Code 20060320 Instruction Manual SEL-311C Relay
Inputs, Outputs, Timers, and Other Control Logic
Rotating Default Display (Only on Models With LCD)
➤ i is a number between 1 and 16, representing the 16 display
points, and j is either 1 or 0 representing logic high or low,
respectively.
➤ XXX is an optional pre-label. YYY is an optional post label that
is preceded by a single semicolon (;) character. The label
character count is the sum of the characters used in the pre and
post labels.
➤ ABCDE is a relay setting variable from Table 7 .10.
For example, setting DP1_0 = OC PU;;51PP;A will display:
Or setting DP1_0 = OC PU;;;001;A will display:
Displaying Metering
Quantities on the
Rotating Default
Display
Display points can be programmed to display metering quantities
automatically, making this information available without the use of
pushbuttons. The values shown in Tab le 7 .11 can be set to automatically
display on the rotating LCD screen.
Table 7.10 Relay Setting Variables
SET T Setting
Variable
Displays Relay
Setting Value
Display
Form a t/
Resolution
Maximum Label
Character Count
;;51PP 51PP xxxxxxx.xx 6
;;51GP 51GP xxxxxxx.xx 6
;;51QP 51QP xxxxxxx.xx 6
;;;000 51PP xxxxxxx 9
;;;001 51GP xxxxxxx 9
;;;002 51QP xxxxxxx 9
OC PU 1200.00A
OC PU 1200A