Schweitzer Engineering Laboratories SEL-311C - Settings Sheet-DNP Port-Set P

Date Code 20060320 Instruction Manual SEL-311C Relay
Date _______________ 1 of 2Settings Sheet—DNP Port—Set P
Settings Sheet—DNP Port—Set P
Protocol (SEL, LMD, DNP, MBA, MBB, MB8A, MB8B) PROTO = DNP
Baud rate (300,600,1200,2400,4800,9600,19200,38400)
(38400 is not available on Port 1.)
SPEED =
DNP Address (0–65534)
DNPADR =
Class for event data (0 for no event, 1–3)
ECLASS =
Time-set request interval, minutes (0 for never, 1–32767)
TIMERQ =
Currents scaling (0–3 decimal places)
DECPLA =
Voltages scaling (0–3 decimal places)
DECPLV =
Miscellaneous data scaling (0–3 decimal places)
DECPLM =
Select/Operate time-out interval, seconds (0.0–30.0)
STIMEO =
Number of data-link retries (0 for no confirm, 1–15)
DRETRY =
Data Link Time-out interval, seconds (0–5)
DTIMEO =
Minimum Delay from DCD to transmission, seconds
(0.00–1.00)
MINDLY =
Maximum Delay from DCD to transmission, seconds
(0.00–1.00)
MAXDLY =
Transmission delay from RTS assertion, seconds
(OFF, 0.00–30.00)
PREDLY =
Post-transmit RTS deassertion delay, seconds (0.00–30.00)
PSTDLY =
Analog reporting dead band, counts (0–32767)
ANADB =
Allow Unsolicited Reporting (Y/N)
UNSOL =
Enable unsolicited messages on power up (Y/N)
PUNSOL =
Address of master to Report to (0–65534)
REPADR =
Number of events to transmit on (1–200)
NUMEVE =
Age of oldest event to force transmit on, seconds (0.0–60.0)
AGEEVE =
Time-out for confirmation of unsolicited message,
seconds (0–50)
UTIMEO =