Schweitzer Engineering Laboratories SEL-311C - Rotating Default Display

11.12
SEL-311C Relay Instruction Manual Date Code 20060320
Front-Panel Interface (Only on Models With LCD)
Rotating Default Display
Rotating Default Display
The local and remote channel IA, IB, and IC current values (in primary Amps)
display continually if no local control is operational (i.e., no corresponding
switch position label settings were made) and no display point labels are
enabled for display.
The
Press CNTRL for Local Control message displays in rotation (display
time = SCROLD) with the default metering screen if at least one local control
switch is operational. It is a reminder of how to access the local control
function. See the preceding discussion in this section and Local Control
Switches on page 7.7 for more information on local control.
If display point labels (e.g.,
79 DISABLED and BREAKER OPEN) are enabled for
display, they also enter into the display rotation (display time = SCROLD).
RECLOSER
9
1
BCG
TIMETRIP COMM
ZONE/LEVEL
123
51
SOTF RS
FAULT TYPE
PORT F
SERIAL
98
354
A
67
21
EN LO
4
IA=50 IB=50
IC=50
RECLOSER
9
1
BCG
TIMETRIP COMM
ZONE/LEVEL
123
51
SOTF RS
FAULT TYPE
PORT F
SERIAL
98
354
A
67
21
EN LO
4
Press CNTRL for
Local Control
IA=50 IB=50
IC=50