Schweitzer Engineering Laboratories SEL-311C - Table 10.7 SHO Command Options

10.25
Date Code 20060320 Instruction Manual SEL-311C Relay
Serial Port Communications and Commands
Command Explanations
QUI Command (Quit Access Level)
The QUI command returns the relay to Access Level 0.
To return to Access Level 0, enter the command:
=>QUI <Enter>
The relay sets the port access level to 0 and responds:
SEL-311C POTT Date: 10/12/99 Time: 16:32:10.747
EXAMPLE: BUS B, BREAKER 3
=
The = prompt indicates the relay is back in Access Level 0.
The QUI command terminates the SEL Distributed Port Switch Protocol
(LMD) connection if it is established (see Appendix C: SEL Distributed Port
Switch Protocol (LMD) for details on SEL Distributed Port Switch Protocol
[LMD]).
SER Command (Sequential Events Recorder Report)
Use the SER command to view the Sequential Events Recorder report. For
more information on SER reports, see Section 12: Standard Event Reports and
SER.
SHO Command (Show/View Settings)
Use the SHO command to view relay settings, SELOGIC control equations,
global settings, serial port settings, sequential events recorder (SER) settings,
and text label settings. Below are the SHO command options.
You may append a setting name to each of the commands to specify the first
setting to display (e.g., SHO 1 E50P displays the setting Group 1 relay
settings starting with setting E50P). The default is the first setting.
The SHO commands display only the enabled settings. To display all settings,
including disabled/hidden settings, append an A to the SHO command (e.g.,
SHO 1 A).
Table 10.7 SHO Command Options
SHO Command Description
SHO n Show relay settings. n specifies the setting group (1, 2, 3, 4, 5,
or 6); n defaults to the active setting group if not listed.
SHO L n Show SEL
OGIC control equation settings.
n specifies the setting group (1, 2, 3, 4, 5, or 6);
n defaults to the active setting group if not listed.
SHO G Show global settings.
SHO P n Show serial port settings. n specifies the port (1, 2, 3, or F);
n defaults to the active port if not listed.
SHO R Show sequential events recorder (SER) settings.
SHO T Show text label settings.