Schweitzer Engineering Laboratories SEL-311C - Figure B.3 Determining Communications Parameters for the Computer; Figure B.4 Setting Terminal Emulation

B.4
SEL-311C Relay Instruction Manual Date Code 20060320
Firmware Upgrade Instructions
If the computer settings do not match the relay settings,
change the computer settings to match the relay
settings.
b. Click OK.
Figure B.3 Determining Communications Parameters for the Computer
Step 7. Set the terminal emulation to VT100:
a. From the File menu, choose Properties.
b. Select the Settings tab in the Firmware Upgrade
Properties dialog box (Figure B.4).
c. Select VT100 from the Emulation list box and click
OK.
Figure B.4 Setting Terminal Emulation
Step 8. Confirm serial communication.
Press <Enter>. In the terminal emulation window, you should
see the Access Level 0 = prompt, similar to that in Figure B.5.
If this is successful, proceed to C. Save Settings and Other
Data on page B.6.