Schweitzer Engineering Laboratories SEL-311C - Page Numbering

xxiv
SEL-311C Relay Instruction Manual Date Code 20060320
Preface
➤ Appendix G: SEL Synchrophasors
➤ Appendix H: Setting SELOGIC Control Equations
➤ Appendix I: DNP Communications
➤ Appendix J: MIRRORED BITS Communications
➤ Appendix K: Unsolicited Fast SER Protocol
➤ Appendix L: ACSELERATOR QuickSet SEL-5030 Software
SEL-311C Relay Command Summary. Briefly describes the serial port
commands that are described in detail in Section 10: Serial Port
Communications and Commands.
Page Numbering
This manual shows page identifiers at the top of each page; see the figure
below.
Page Number Format
The page number appears at the outside edge of each page; a vertical bar
separates the page number from the page title block. The page numbers of the
SEL-311C Relay Instruction Manual are represented by the following
building blocks:
➤ Section number
➤ Actual page number in the particular section
The section title is at the top of the page title block, with the main subsection
reference in bold type underneath the section title.
Installation
Title Block Page Number
Making Rear-Panel Connections
2.13