A.7
Date Code 20060320 Instruction Manual SEL-311C Relay
Firmware and Instruction Manual Versions
Instruction Manual
Appendix L
➤ Updated the name of ACSELERATOR SEL-5030 Software
to
ACSELERATOR QuickSet SEL-5030 Software.
This manual differs from the previous versions as follows:
20051215 ➤ Made typographical and proofreading corrections throughout the manual.
Section 2
➤ Corrected Figure 2.14, SEL-311C Provides Distance and Overcurrent Protection and Reclosing for a
Transmission Line (Current-Polarization Source Connected to Channel IP).
Section 3
➤ Corrected Figure 3.4, Zone 1 AB Phase Distance Logic.
Appendix A
➤ Corrected Firmware Revision History table (Table A.1) showing that the addition of the STA C com-
mand occurred with firmware revision R104.
Appendix I
➤ Added Table I.1, Error Types Reported by the Communications Report.
This manual differs from the previous versions as follows:
20050415
➤ Updated instruction manual format.
Section 2
➤ Added hardware drawings.
Section 4
➤ Corrected power factor (reverse load) equations in Convert Power Factors to Equivalent Load Angles.
This manual differs from the previous versions as follows:
20050114
Appendix A
➤ Updated firmware and Firmware Revision History table (Ta bl e A .1 ).
This manual differs from the previous versions as follows:
20030728
Appendix A
➤ Updated firmware and Firmware Revision History table.
This manual differs from the previous versions as follows:
20020703 ➤ Removed Manual Change Information section and incorporated the information into the Instruction
Manual Revision History table (Ta bl e A. 3) in Appendix A: Firmware and Instruction Manual
Ve rs i on s .
Appendix A
➤ Updated firmware and Firmware Revision History table (Ta bl e A .1 ).
➤ Added Instruction Manual Revision History table (Table A.3).
Appendix B
➤ Updated firmware upgrade instructions.
This manual differs from the previous versions as follows:
20020603
Section 5
➤ Updated information in the 51 Target LED and Zone LED sections.
Section 10
➤ Updated BRE W command screen capture in section BRE n Command (Preload/Reset Breaker Wear).
Section 14
➤ Updated Applications Setting Sheets.
Appendix K
➤ Added Appendix K: ACSELERATOR
®
SEL-5030 Software.
This manual differs from the previous versions as follows:
20011205
Reissued entire manual to reflect the following changes:
➤ Updated Section 2 and Section 3 figure references throughout the manual.
Table A.3 Instruction Manual Revision History (Sheet 3 of 6)
Revision Date Summary of Revisions
To Next Page
