Schweitzer Engineering SEL-2032 - Page 15

xiii
Date Code 20120126 Instruction Manual SEL-2032 Communications Processor
Preface
Manual Overview
Collect Data From Non-SEL Devices.
Section 1: Introduction and Specifications
Example 4: Collect Unsolicited Write (Synchrophasor) Data on
page 3.19
SEL Application Guides
Provide Data to a Modbus Master.
Section 1: Introduction and Specifications
Example 6: Modbus Job Done on page 3.26
Port Configuration (SET P) and Communication Settings on page 7.2
Modbus RTU Protocol on page 9.8
Provide Data to a DNP 3.0 Master (Serial).
Section 1: Introduction and Specifications
Port Configuration (SET P) and Communication Settings on page 7.2
Serial Distributed Network Protocol (Serial DNP3) on page 9.27
Distributed Network Protocol 3.0 (DNP3) LAN/WAN on page 9.43
Provide Data to a DNP 3.0 Master (Ethernet).
Section 1: Introduction and Specifications
Distributed Network Protocol 3.0 (DNP3) LAN/WAN on page 9.43
Install Protocol Cards.
SEL-2701 Instruction Manual
SEL-2711 Instruction Manual
Upgrade Firmware.
Appendix B: Firmware Upgrade Instructions
Replace Battery.
Battery Replacement on page 10.5
Provide Ethernet Connections.
SEL-2701 Product Information Sheet
SEL-2701 Instruction Manual
SEL-2890 Product Information Sheet
SEL-2890 Instruction Manual
Use SEL-2032 as a Port Switch.
Intelligent Port Switch on page 1.2
Example 2: Using the SEL-2032 as a Port Switch on page 3.4
Port Configuration (SET P) and Communication Settings on page 7.2
Time Synchronize Relays.
Time Synchronization Source on page 1.2
SEL Relay Instruction Manuals
SEL-5801 Cable Selector Software (available at www.selinc.com)
Courtesy of NationalSwitchgear.com