9.27
Date Code 20120126 Instruction Manual SEL-2032 Communications Processor
Protocols
Serial Distributed Network Protocol (Serial DNP3)
Register Map
for User Data
Serial Distributed Network Protocol (Serial DNP3)
Overview
The SEL-2032 supports DNP 3.0 Level 2 Slave protocol serially on Port 16. It
can be used for data access and for control. For a complete description of this
protocol, refer to the DNP Basic Four Documentation Set and the DNP V3.00
Subset Definition, both of which are available from the DNP User’s Group at
www.dnp.org.
For information on DNP3 over an Ethernet connection, see Distributed
Network Protocol 3.0 (DNP3) LAN/WAN on page 9.43.
2209(R) Breaker Last reset Date stamp Month 1–12
2210(R) Breaker Last reset Date stamp Day of the Month 1–31
2211(R) Breaker Last reset Date stamp Year 0–99
2212(R) Breaker Last reset Time stamp Hours 0–23
2213(R) Breaker Last reset Time stamp Minutes 0–59
2214(R) Breaker Last reset Time stamp Seconds 0–59
2215(R) IA kA/10, primary 0.00–3276.7 kA, pri
2216(R) IB kA/10, primary 0.00–3276.7 kA, pri
2217(R) IC kA/10, primary 0.00–3276.7 kA, pri
2218(R) Ext Trips None Integer
2219(R) Breaker Last reset Date stamp Month 1–12
2220(R) Breaker Last reset Date stamp Day of the Month 1–31
2221(R) Breaker Last reset Date stamp Year 0–99
2222(R) Breaker Last reset Time stamp Hours 0–23
2223(R) Breaker Last reset Time stamp Minutes 0–59
2224(R) Breaker Last reset Time stamp Seconds 0–59
2225(R) IA kA/10, primary 0.00–3276.7 kA, pri
2226(R) IB kA/10, primary 0.00–3276.7 kA, pri
2227(R) IC kA/10, primary 0.00–3276.7 kA, pri
Table 9.13 Register Map for Breaker Data, Integer Type (Sheet 2 of 2)
Reg.# Description Units Range
Table 9.14 Example Register Map for User Data
a
a
The actual number of User region registers available depends on the SET A USER setting on
the port.
Reg.# Description Units Range
2400(R) First User Register — —
•
•
•
•
•
•
•
•
•
•
•
•
4446(R) Last User Register — —
Courtesy of NationalSwitchgear.com
To Next Page
Loading...