8.3
Date Code 20120126 Instruction Manual SEL-2032 Communications Processor
Serial Port Communications and Commands
Command Set
Changing
Access Levels
The SEL-2032 always reverts to Access Level 0 at power-up, after time-out,
and when you issue the QUIT command at the end of a communication
session. To access Level 1, you must type ACCESS <Enter> at the ā*ā
prompt and then enter the password. To enter Access Level 2 from Access
Level 1, use the 2ACCESS command and the Access Level 2 password. If the
password disable jumper is installed on the main board, a password is not
required to change access levels. See Jumper Settings on page 2.1 for
information on installing jumpers.)
To return to Access Level 0, use the QUIT command. The port automatically
returns to Access Level 0 after no activity has occurred on the port for the
specified time-out interval.
See the following paragraphs for the details of using the ACCESS,
2ACCESS, and QUIT commands.
Command Set
This section describes all SEL-2032 commands in alphabetical order. The
minimum access level for each command is indicated in parentheses after the
command name. See Table 8.1 for a complete summary of command access
levels.
HELP
ID
HELP
ID
IRIG
HELP
ID
IRIG
L_D
b
MAP
MEM
MODMAP
MAP
MEM
MODMAP
PASSWORD
PORT PORT
QUIT QUIT
SER
QUIT
SER
SET
SHOWSET
STATUS
SHOWSET
STATUS
STORE
SWAP
TARGET
TIME
TARGET
TIME
TOGGLE
VIEW
WHO
VIEW
WHO
a
The DCF command is only available on virtual terminal connections.
b
The L_D command is only available on Port F of the SEL-2032.
Table 8.1 Access Level Characteristics (Sheet 2 of 2)
Access Level 0 1 2
Prompt * *> *>>
Courtesy of NationalSwitchgear.com
To Next Page
Loading...