Schweitzer Engineering SEL-2032 - Figure 9.6 SEL-5020: Set DNP Map Mode to CUSTOM; Figure 9.7 SEL-5020: Assign Custom DNP3 Map to Master

9.57
Date Code 20120126 Instruction Manual SEL-2032 Communications Processor
Protocols
Distributed Network Protocol 3.0 (DNP3) LAN/WAN
Figure 9.6 SEL-5020: Set DNP Map Mode to CUSTOM
Figure 9.7 SEL-5020: Assign Custom DNP3 Map to Master
When the Ethernet port has been configured to use custom DNP3 maps, the
SEL-2701 will obtain these maps from the Communications Processor
Settings subdirectory. Custom maps saved in a communications processor
have filenames of the form SET_DNPxyy.TXT, where x is the map number
(1–5), and yy is the port number (17 or 18).
The settings described in Table 9.31 are used to define the custom DNP3
maps. Note that these settings are only accessible as files in the SETTINGS
subdirectory or by using the SEL-5020 Settings Assistant. The latter is
Courtesy of NationalSwitchgear.com