EasyManua.ls Logo

Schweitzer Engineering SEL-2032 - Appendix A: Firmware and Manual Versions Firmware

Schweitzer Engineering SEL-2032
354 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A.2
SEL-2032 Communications Processor Instruction Manual Date Code 20120126
Firmware and Manual Versions
Firmware
SEL-2032-R110-V0-Z003001-D20080110 ➤ Enhanced Direct Transparent functionality to allow
ACSELERATOR QuickSet
®
SEL-5030 Software connections via
the front port or SEL-2701 Ethernet Processor to a downstream-
connected relay.
➤ Allowed SET M equations to continue to execute during an active
Direct Transparent connection on the port.
➤ Fixed issue where Null characters may be dropped during
Transparent connections.
➤ Auto-disabled Xon/Xoff handshaking during SEL-5020
YMODEM file transfers.
➤ Improved storage capacity for relay configuration information.
➤ Corrected power miscalculation for older connected relays.
20080110
SEL-2032-R109-V0-Z003001-D20070629 ➤ Enhanced security by adding NOCONN functionality for SEL
Master ports.
20070629
SEL-2032-R108-V0-Z003001-D20070208 Note: This firmware version was not production released. See R109
above.
➤ Added SP_RATE setting for support of SEL Fast Messaging for
synchrophasors.
20070208
SEL-2032-R107-V0-Z002001-D20061122
➤ ASCII Automatic Messages and ASCII Operate commands issued
while a port’s status is inactive will no longer be queued and sent
once that port’s status returns to an active state.
20061122
SEL-2032-R106-V0-Z002001-D20060214
➤ Improved efficiency of Modbus
®
function code 03 and 04 reads.
➤ Extended duration of MSET bit assertion to insure that the bit is
available for SEL
OGIC
®
equations.
20060214
SEL-2032-R105-V0-Z002001-D20051107 ➤ Switching a port protocol from Modbus to SEL Master with
unsolicited write (\W) commands does not cause a lockup.
➤ Added precision time-tagging from FAST SER messages and
local data into the data transferred from the host to the SEL-2701.
➤ Added the capability to configure and use up to five custom DNP3
maps.
20051107
SEL-2032-R104-V0-Z002001-D20050801
➤ Added DCF command and diagnostic functions
20050801
SEL-2032-R103-V0-Z000000-D20041222
➤ Corrected SEL Binary SER mapping to DNP3 event message
function.
20041222
SEL-2032-R102-V0-Z000000-D20030605
➤ Increased available message processing RAM.
20030605
SEL-2032-R101-V0-Z000000-D20030312
➤ Enabled \W messaging for both Master and SEL ports.
➤ Improved performance of serial port buffering and unsolicited
message handling.
20030312
SEL-2032-R100-V0-Z000000-D20030115
➤ Initial version.
20030115
Table A.1 Firmware Revision History—SEL-2032 Instruction Manual (Sheet 2 of 2)
Firmware Identification (FID) Number Description of Changes
Manual
Date Code
Courtesy of NationalSwitchgear.com

Table of Contents