Schweitzer Engineering SEL-2032 - Page 320

A.4
SEL-2032 Communications Processor Instruction Manual Date Code 20120126
Firmware and Manual Versions
Instruction Manual
20070208
Section 3
➤ Added Example 4: Collect Unsolicited Write (Synchrophasor) Data.
Section 7
➤ Added fifth bullet to Automatic Message (SET A) Settings.
➤ Added SP_RATE information in Table 7.6.
Settings Sheets
➤ Added SP_RATE setting to Settings Sheet—SEL IED, SET P and SET A.
Section 9
➤ Updated SEL IEDs and the SEL-2032.
➤ Moved Sequential Events Recorder (SER) Data from Section 7 to Section 9.
➤ Updated first paragraph and Step 3 in Sequential Events Recorder (SER) Data.
➤ Added SEL Fast Message Synchrophasor Protocol in SEL Fast Message Protocol.
➤ Updated Output Objects: DNP_PAIR = N.
Appendix A
➤ Updated for firmware version R108.
Appendix B
➤ Deleted Using Compressed File Formats.
➤ Added Step 4 to Prepare for Firmware Upgrade.
20061122
Section 4
➤ Added Communications and Triggered Messages.
Appendix A
➤ Updated for firmware version R107.
20060214
Section 3
➤ Added 20USER memory copy example to Modbus Job Done.
Section 9
➤ Revised Timing in Modbus RTU Protocol.
➤ Expanded descriptions of function codes 03h and 04h in Function Codes.
20051107
➤ Reissued entire manual to include DNP3 for LAN/WAN support.
Appendix A
➤ Updated Firmware and Manual Version tables.
20050801
Section 5
➤ Added data format “d=binary default” for “\Rt;saddr[;n]/” in Table 5.2.
Section 6
➤ Added the overrun bit to Figure 6.6 and Figure 6.7.
Section 7
➤ Added DCF command to Virtual Terminal Communications and modified SET commands in Figure 7.1.
Section 8
➤ Added DCF command to Table 8.1 and describe DCF.
➤ Added overrun statistics, last reset, and Ram Allocation Failure indications to STATUS command.
Appendix A
➤ Updated Firmware and Manual Version tables.
20041222
Appendix A
➤ Updated Firmware and Manual Version tables.
20030605
Section 5
➤ Added \W message limit to Table 5.2.
Section 9
➤ Added breaker bit usage description to AUTO command example.
➤ Corrected virtual terminal support in DNP3 Device Profile Document in Table 9.17.
Appendix A
➤ Updated Firmware and Manual Version tables.
Table A.2 Instruction Manual Revision History (Sheet 2 of 3)
Revision Date Summary of Revisions
Courtesy of NationalSwitchgear.com