Section 05 ELECTRICA L SYSTEM
Subsection 05 (RADIO FREQUENCY DIGITALLY ENCODED SECU-
RITY SYSTEM (RF D.E.S.S.))
5. Ensure that anti-theft system is activated. If
not, activate it before trying to add a key.
6. Install new key on the D.E.S.S. post.
7. Press the READ button (top right of the table).
8. Select key type
9. Press ADD button to register the key. The new
key should be displayed in the table. Repeat
steps 6 to 9 to add other keys.
Erasing Keys
1. Install the tether cord on the engine cut-off
switch.
2191008
93-026-001_a
2. Click on Erase Key.
After a
pproximately 10 seconds the following
messag
e will appear.
The key is now erased.
Erasing All Keys
1. Click o
n Erase All Keys.
2. When done, program at least one new key to
the vehicle. Refer to
ADDING A KEY
in this sub-
section.
D.E.S
.S. / Engine Cut-Off Operation
Normal Operation
The electrical system provides power to RFID-D.
The ECM provides 5Vdc to the DESS module
DS-C. The ECM provides a ground to the DESS
module DS-A. When a key (tether cord) is installed
on the DESS post, a hall effect switch closes and
sends a 12-15Vdc s ignal to the ECM.
Refer to
IGNITION SYSTEM
subsection for test-
ing procedures.
219100893-026 137
To Next Page
Loading...
Need help?
General
