Section 03 ELECTRONIC MANAGEMENT SYSTEMS
Subsection 05 (DIAGNOSTIC AND FAULT CODES)
Beeper Signals
When one of the below conditions occurs, the monitoring system emits the following beep signals.
BEEPER CODES DESCRIPTION
Bad D.E.S.S. system connection.
Reinstall tether cord correctly over engine cut-off switch.
Wrong D.E.S.S
.key.
Use a tether cord with a D.E.S.S. key that has been programmed for the
watercraft.
Defective D.E.S.S. key.
Use another programmed D .E.S.S. key.
Defective engine cut-off switch.
Check. Refer to
IGNITION SYSTEM
subsection.
A 1 second beep
every 5 secon d interval
(while installing D.E.S.S. key
on engine cut-off switch if ECM
is on)
Improper operation of ECM or defective wiring harness.
Check. Refer to
ELECTRONIC FUEL INJECTION (EFI)
subsection.
Low fuel level.
Refill fuel tank. If problem persists, check sensor and circuit. R efer to
FUEL
TANK AND FU
EL PUMP
subsection.
A 2 seco nd beep every 5 minute
interval
Fuel tank level sensor or circuit malfunction.
Check sensor and circuit. Refer to
FUEL TANK AND FUEL PUMP
subsection.
High engin
e coolant temperature.
Refer to
COOLING SYSTEM
subsectio n.
High exhaust temperature.
Refer to
ELECTRONIC FUEL INJECTION (EFI)
subsectio n.
Continuously beeps
Low oil pr
essure.
Turn off engine as soon as possible. Ch e c k oil level and refill. R efer to
LUBRICATION SYST EM
subsection.
76 219100893-019
To Next Page
Loading...
