111
2. Cruise control switch
1) Press the cruise control switch from the
“OFF” position and hold the switch to the
“SET” position. Observe the ohmmeter.
2) Using an ohmmeter, touch one ohmmeter
test prove to terminal 5 of the cruise
control switch. Touch the other ohmmeter
probe to terminal 6.
3) The ohmmeter should show little or no
resistance indicating continuity.
4) If there is no continuity, the switch is
defective and needs replaced.
5) Touch one ohmmeter test probe to terminal
2 and the other probe to terminal 3.
6) The ohmmeter should show little or no
resistance indicating continuity.
7) If there is no continuity, the switch is
defective and needs replaced.
8) Continue to hold ohmmeter test probes to
terminal 2 and 3 of the switch and let the
switch rocker from the “SET” position to
the “ON” position. Observe the ohmmeter.
The ohmmeter should show little or no
resistance indicating continuity. If there is
no continuity, the switch is defective and
needs replaced.
399YI
399YJ
399YK
399YL
To Next Page
Loading...
